The S360 box
      Back to home
      1. Secury360 Knowledge Base
      2. The S360 box

      Assembly of a 3.5" HDD in the S360 box V3

      A step-by-step guide on how to properly assemble and install a 3.5" hard disk drive (HDD) into the Secury360 system for storage purposes.

      1. Remove the cover

      • Detach the ‘No Fan Cover’ to access the inside of the S360 Box V3.

      2. Prepare the 3.5” HDD

      • Attach the brackets (2x 80.09.0002.C) to the 3.5” HDD using the screws (6x 80.02.0045).
      • Ensure the connector side of the HDD faces outward and aligns with the labels on the brackets.
      • Do not fully tighten the screws yet.
      • Place the brackets on a flat surface and tighten the screws in a crossed sequence to ensure the HDD’s bottom surface is flat.

      3. Mount the 3.5” HDD

      • Tilt the prepared HDD assembly and insert the brackets into the slots labeled “HD35” inside the S360 Box V3.
      • Align the HDD connector with the connector on the PCB.
      • Lower the HDD assembly until the HD guide fits into the groove on the side of the bracket.
      • Slide the HDD until it clicks securely into the PCB connector.
      • Secure the HDD assembly with 4x 80.02.0043 screws.

      4. Reattach the cover

      • Replace the ‘No Fan Cover’ to close the S360 Box V3.